The precise and effective Trichogramma (or parasitic wasp) spreading system utilizes one of the most widely used biological control methods. Its 8-liter tank can hold up to 800-1200 pellets – depending on pellet size. This allows up to 8-12 hectares to be treated in one take-off.
The Trichogramma spreading system is available for the ABZ Innovation L10 PRO and M12 models. To be able to install the trichogramma spreader, the drone must be equipped with the necessary connectors and cables, which can be installed at the regional ABZ service center.
To plan an operation with the Trichogramma Spreader, you need to install Mission Planner on your computer and carry out an initial configuration. During mission planning and operation, the Trichogramma Spreader is treated like a camera by the system. The trichogramma balls are dropped at the points where the camera would take a picture.
To equip the drone with the spreader, place the clamps of the trichogramma spreader on the frame over the serial number label. The display attached to the Trichogramma

Spreader should point toward the front cover of the drone.

Go to the other side of the drone. Pull the clamps of the trichogramma spreader towards you until they reach over the frame. Push the clamps upwards to lock them in position. Plug in the cable of the Trichogramma Spreader to the metal connector. For the correct alignment of the connector’s male and female sides, follow the guidance of the notches. Secure the connector with the nut.
For further instruction about the control and operation of the Trichogramma Spreader, please refer to the user manual.

Title	Author	Date	Tags